The data transfer speed in RS depends on the distance and can vary from 10 kbps meters to 10 Mbps 10 meters. In the RS network, there can only be one transmitting device and up to 10 receiving devices. The RS line is 4 wires for data transmission 2 twisted wires for transmission and 2 twisted wires for receiving and one common GND ground wire.
Twisting wires twisted pair with each other allows you to get rid of interference and interference, because the interference acts equally on both wires, and the information is extracted from the potential difference between the conductors A and B of one line. Logical 1 corresponds to the difference between A and B less than The RS standard does not define a specific type of connector, usually it can be a terminal block or a DB9 connector.
RS pinout depends on the manufacturer of the device and is specified in the documentation for it. Because the distance between the receiver and the transmitter RS can reach meters, then to prevent reflection of the signal from the end of the line, a special ohm termination resistor or "terminator" is put. Then you can use the software to work with the COM port. Description of the RS interface In industry, the most common interface is RS EIA , because the RS uses a multi-point topology, which allows you to connect several receivers and transmitters.
The RS interface is similar to the RS in that it also uses a differential signal for data transmission. There are two types of RS RS with 2 contacts, operates in half duplex mode RS with 4 contacts, operates in full duplex mode In full duplex mode, you can simultaneously receive and transmit data, and in half-duplex mode either transmit or receive. In one segment of the RS network there can be up to 32 devices, but with the help of additional repeaters and signal amplifiers up to devices.
At one time, only one transmitter can be active. How to Adjust Scope Probe Compensation. Supplier Directory For everything from distribution to test equipment, components and more, our directory covers it. Featured articles.
Since it allows for connections with few signal wires, one of its merits is its ability to hold down on wiring material and relaying equipment costs. Of these communication standards, RSC has been widely adopted in a variety of applications, and it is even standard equipment on computers and is often used to connect modems and mice. Sensors and actuators also contain these interfaces, many of which can be controlled via serial communication.
This serial communication standard is widely used and is often equipped on computers as standard. It is also called "EIA". The purpose and timing of the signal lines and the connectors have been defined D-sub pin or D-sub 9-pin. However, even now it is generally referred to as "RSC". This standard fixes problems in RSC such as a short transmission distance and a slow transmission speed.
They are also capable to support cloud or network systems. The construction of RS is designed so that it can deal with a greater noise level and is compatible with transmitting the data through a long cable. Basically, RS is fixed between the two ends of transmitter and receiver.
It can provide data up to 10 receivers and it is possible with the help of differential current drive output, which offers high support to suppress noise. According to the operations of RS, it can be said that it is consummate to transmit data for long connections, which is better than RS and Ethernet. Your email address will not be published. Save my name, email, and website in this browser for the next time I comment. Notify me of new posts by email. Don't subscribe All Replies to my comments Notify me of followup comments via e-mail.
You can also subscribe without commenting. Skip to content. This post was published by Admin. Email: admin TheCloudStrap.
0コメント